Versions Compared
compared with
Key
- This line was added.
- This line was removed.
- Formatting was changed.
Overview
Two HiRose FX10A-168P-SV1(71) connectors are required to interface Opal to a base-board.
Opal has two 2.7mm (0.106") mounting holes size to 2.7mm. Use plastic screws or washers and ensure the screw head has a maximum size of 5mm (0.197").
The dimensions on the following diagram are in mm. Click the image for a larger view.
The location of the connectors are 3.6mm from the edge of the board for one and 4.6mm for the other.
Connector PCB Footprint
The following diagram is taken from the FX10A data sheet.
A | 41.5mm |
---|---|
C | 44.4mm |
D | 49.5mm |
E | 46.3mm |
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|
Stacking Height
The total height of the Opal module when connected to a base-board is 9mm including both connectors.
Panel | ||
---|---|---|
| ||
|